ONE-SIXTY 8000

Uporaba stožčaste cevi dimenzij in ležaja 1 1/8 "na vrhu in 1 1/4" ali 1 1/2 "na dnu ustvarja izjemno togost in natančno, zanesljivo navdušujoče krmiljenje.

Bovdni napeljavi skozi okvir nudijo sodoben izgled kolesa, medtem ko so kabli ustrezno zaščiteni pred vlago in umazanijo.

Da bi zaščitili celovitost karbonskih okvirjev so vlakna vezana skupaj z epoksidno smolo in dodanimi nano delci, kar povečuje odpornost na udarce za 40%.

Pri ustvarjanju posameznih ogljikovih elementov se uporablja napihljiv mehur, ki zagotavlja, da v cevi ni gub, saj lahko te dodajo težo in ustvarijo šibkost. Rezultat je svetlejši, trdnejši in močnejši okvir.

Izbrane vijake lahko zategnemo z klučem TORX 30 samo z ene strani, ne da bi pri tem prišlo do nevarnosti, da bi se nasprotna stran zdrsnila ali se zavrtela, kar omogoča hitrejše in enostavnejše privijanje pomembnih komponent opreme.

A suspension design where the traditional pivot point on the seat stay is eliminated in favour of a flexstay design. This uses the compliance of the material and specific shaping of the tubes to allow for the seat and chain stays to move apart as the suspension moves through the travel. By removing this pivot point at the seat and chain stay junction, we save weight, reduce maintenance needs and add stiffness to the frame structure.

MERIDA designed headsets that enable all control cables from the handlebar to enter the frame through the headset cover, creating a clean and uncluttered look, allowing for a lighter, stronger and more aerodynamic frame structure than with conventional cable ports. Depending on the model, the cables are run completely internally (including the bar and stem) or semi-integrated, where the cables enter the frame underneath the stem.

Rear suspension kinematic that uses a flexstay design to minimise weight and maintenance needs. Each frame size has a specific progression rate, with longer reach models having increased progression to better suit harder and/or heavier riders. An adjustable flip chip can be used to run full 29er or mixed-size wheels while preserving the geometry for consistent handling. Flexstay-Adjustable-Size-Tuned kinematic: FAST, because it is.

Mounting points for an optional extra-long fender to boost protection over the standard short fender. The full-length fender reduces the amount of dirt and water spray from the rear wheel, keeping the rider cleaner and drier and also extending the life of bearings and cables. The bolt-on mounting points mean the fender is fixed rigidly, so there is less noise, and the paint finish of the bike is not damaged.

An easy-to-remove cover underneath the bottom bracket used on specific carbon fibre frames provides easy access to all hoses and cables that run through the down tube towards the rear of the bike. The large port makes it much easier to maintain or replace brake hoses and derailleur cables, speeding up service procedures. The port can also be used to store tools and essential small parts in the downtube of the bike, when used in conjunction with our ESSENTIAL TOOL WRAP.